Toro 69X-01-XX Bedienungsanleitung PDF herunterladen

Introduction

The 690 Series Rotary Sprinkler is designed for irrigation of large turf areas such as golf courses, parks,

recreational fields and school grounds.

Manufactured from durable, high strength engineering plastic and stainless steel components, the 690 sprinkler

incorporates many innovative and time proven features for lasting, maintenance-free operation. Some of these

features are listed below.

INSTALLATION & SERVICE INSTRUCTIONS

690 Series Rotary Sprinkler

Features

• Positive Spring Retraction - Pulls nozzle and cap down out of the

way of people and turf maintenance equipment.

• Three Nozzle Sizes - Multiple nozzle sizes provide 45.1 to 82.2 GPM

flow and produce watering radii from 78 to 108 feet.

• Long Life Gear Drive - Gear drive mechanism is vacuum-packed with

lubricant and isolated from water stream for long, trouble-free life.

• Valve-In-Head Models - Permits head-by-head control to customize

turf watering for various topography and soil conditions. Multi-cycle for

wind or runoff problems, frost control and dew removal without low-head

drainage. Available for hydraulic normally open or 24 Volt electric

systems.

• Sprinkler Operating Mode - Electric valve-in-head models have three

modes of operation; AUTO, ON and OFF. Mode is set using a selector

tool inserted through the sprinkler body flange.

• Built-in Check Valve - Check-o-matic sprinklers utilize a check valve in

the sprinkler base to prevent seepage from low area heads after valve

closure. Check valve will hold up to 35 feet of elevation differential.

• Two-Speed / 60°-120° Models - Provides for more even precipitation.

Runs at half speed in non-overlapping areas.

• Two-Speed / 180° Models - Provides for more even precipitation

where only a selected area is covered by an overlap, such as is found on

greens. Runs at half speed in non-overlapping areas.

• Serviceability - All internal parts of the sprinkler are accessible through

the top of the sprinkler body.

Model 69X-06-XX Model 69X-02-XXModel 69X-01-XX

Specifications

• 78 ft. – 108 ft. Radius

• Pop-Up Nozzle and Cap -

⁄8 in.

•1

⁄2 in. NPT Female Thread Inlet

• Recommended Operating

Pressure: 60 – 100 PSI

• Maximum Pressure: 150 PSI

• Electric Models:

– Solenoid - 24 VAC

– Inrush Current - .40 Amps

– Holding Current - .235 Amps

• Dimensions:

– Cap Diameter - 7

⁄2 in.

– Flange Diameter - 10 in.

– Height - 16 in.

1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1 - 690 Series Rotary Sprinkler

IntroductionThe 690 Series Rotary Sprinkler is designed for irrigation of large turf areas such as golf courses, parks,recreational fields and school

Seite 2 - Construct Swing Joints

10Figure 8 690 Series 69X-XX-XXXArc Body Nozzle Pressure Regulation *1 = 90° Quarter Circle 01 = NPT, NO Valve-In-Head 90 8 = 80 PSI2 = 180° Half

Seite 3 - System Start-Up

11Item No. Part No. Nomenclature QuantityPer Assy.1 3-2518 Plug, Cap , Rubber 12 3-3567 Screw, Machine, 1/4 - 20 x3/8" 13 3-3529 Cap Assy., Rubb

Seite 4 - System Troubleshooting

Seite 5 - Sprinklers

2Performance ChartInstallation ProcedureTo assure maximum performance from your 690 Series RotarySprinklers, read these instructions completely prior

Seite 6 - Servicing Procedures

Connecting Electric Control Wires1. Route control wires to sprinkler location(s). Provideenough extra wire at sprinkler to allow formovement of spr

Seite 7

Two-Speed Sprinkler Alignment - Models 696 and 698There are two types of full circle sprinklers which have special arcs of slower then regular speed.

Seite 8

5System Troubleshooting (continued)SprinklersPossible equipment failures with causes and corrective action are listed below.PROBLEM POSSIBLE CAUSE – C

Seite 9

Servicing ProceduresIntroductionThe 690 Series rotary sprinkler is designed to provide the user trouble free operation for many years withoutsche

Seite 10 - Model Number Information

13. To reinstall valve assembly with snap ringand to prevent damage to thecommunication tube in sprinkler body, usevalve insertion tool (P/N 995-11).

Seite 11 - Per Assy

8Servicing Pilot Valve Assembly Note: Assure water supply to sprinkler is positively shut off and all residual pressure has been bled. If sprinkleris

Seite 12

9Figure 7 Pilot Valve, CurrentItem No. Part No. Nomenclature QuantityPer Assy.1 89-1905 Solenoid, Pilot Valve & Valve 12 89-6005 Adapter, Pilo

Verwandte Modelle: 69X-02-XX | 69X-06-XX |

Kommentare zu diesen Handbüchern

Keine Kommentare

Toro 69X-01-XX Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Akustik Toro 69X-01-XX herunter. Toro 69X-01-XX User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: 69X-02-XX | 69X-06-XX |

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Akustik Toro 69X-01-XX