Toro Battery-Operated Hose-End Timer (53746) Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Nein Toro Battery-Operated Hose-End Timer (53746) herunter. Toro Battery-Operated Hose-End Timer (53746) User's Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 1
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Blue Stripe
®
DripBlue Stripe
®
Drip
Battery Operated
Safety Guidelines
This timer is designed for residential outdoor watering use only.
•Detach the timer from the faucet at the end of watering season.
•Do not use with water exceeding 100°F (38°C) or with pressure exceeding
125 PSI.
•Drain all water and remove batteries before storage.
Installation
1. Turn the battery door to the open position using a flat head screwdriver or
coin as shown (see figure 1).
2. Install two AA alkaline batteries (see figure 2) then secure the battery door.
NOTE: Always install new AA alkaline batteries.
3. Before attaching the timer to the outdoor faucet, manually check the timer
operation by turning the duration dial to the “ON” setting. You will hear
the motor in approximately two seconds. This indicates that the batteries
are installed correctly. Return the dial to the “OFF” setting before attaching
the timer to the outdoor faucet.
4. Connect the timer to your outdoor faucet and hose. Be sure all connections
are secure before turning on the water.
Set Watering Frequency
1. To set watering frequency (interval) turn the frequency dial to the
desired length of watering time. The frequency dial can be set to 1, 2, 3,
4, 6, 8, 12, 24, 48, or 72 hours, or to water weekly (once a week).
2. We recommend that you keep a record of the watering schedule (date
and time).
3. Watering frequency will begin after the dial has been set for two seconds.
The frequency dial will reset if it is turned to a new setting for two
seconds.
4. The frequency setting must be longer than the duration setting.
Set Watering Duration
Turn the duration dial to the desired length of watering time. The duration
dial can be set to 1, 3, 10, 15, 20, 30, 45, 60, 90, or 120 minutes. Water
will come on automatically as scheduled.
Start Time Delay
Watering does not immediately start when the frequency dial is set to the
desired interval for operation. The timer has a start time delay that is equivalent
to the number of hours of the programmed watering frequency (interval).
FOR EXAMPLE: At 1:00 PM the frequency dial is programmed for “6” to water
every six hours. The first watering cycle will start at 7:00 p.m. or six hours after the
timer is programmed. Refer to Manual Watering for immediate operation.
Manual Watering
Turn the duration dial to the “ON” setting for manual watering.
Low Battery Indicator
When the battery voltage drops below operating voltage, the timer will no longer operate
and the indicator light will turn on. Replace batteries immediately and reset program.
Part No. 102-3361
No watering operation • Make sure faucet is turned on
• Check duration and frequency dials
• Check the batteries
No manual operation • Check the frequency dial
• Check the batteries
Faucet or hose leaks • Check the washer in the
3
/4" swivel
Tighten the hose swivel connection
TROUBLESHOOTING
READ ALL INSTRUCTIONS BEFORE INSERTING BATTERIES. SAVE THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.
Manual
Watering “ON”
3
/4" Swivel
Faucet Coupling
Frequency Dial
Duration Dial
Low Battery
Indicator Light
3
/4" Hose Connector Battery Compartmen
t
FIGURE 1 FIGURE 2
Model 53746
Seitenansicht 0
1

Inhaltsverzeichnis

Seite 1 - Battery Operated

Blue Stripe® DripBlue Stripe® DripBattery OperatedSafety Guidelines• This timer is designed for residential outdoor watering use only.•Detach the time

Kommentare zu diesen Handbüchern

Keine Kommentare